Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Daily repeat AUTO
Using the function AUTO, you can repeat the sin-
gle automatic switching on and off you selected
every day.
You just need to press the key AUTO (1) for at least
two seconds to activate the function. You will read
the words AUTO (2) on the display of the remote
control. Press SEND (3) to confirm your selection
and transmit it to the pcb of the stove.
The LED chrono-thermostat will light up on the
control board indicating that the programming is
on.
You can deactivate the automatic repeat whenever
you want just pressing the key AUTO again for at
least two seconds. The words AUTO will disappear
from the display. Press SEND (3) to confirm your
selection and transmit it to the pcb of the stove.
Always clean the brazier before starting an automatic switching on in order to
avoid any possible missed starts up which would damage your stove and the
environment.
Replace the batteries of the remote control
If you need to replace the batteries of the remote
control, remove the back cover as shown in the
picture. Replace the old batteries with the new
ones respecting the polarity + and -.
The batteries needed are AAA, 1,5 V.
2
3
1
2
3
1
66
Publicité
Table des Matières
