livin flame Stavanger 6 Mode D'emploi Et D'installation page 64

Function chrono-thermostat
(available only through the remote control)
With the function chrono-thermostat, you can schedule up to two automatic switching on and off of
the stove per day. If you want to repeat the switching on and off every day, then you need to use the
function AUTO too (as explained in the paragraph "Daily repeat AUTO").
• The time of the automatic switching on and off must be set when the remote
control is Off;
• In the event of an even very short lack of current, you will miss the set time
for the automatic switching on or off. Once the power supply is back, please program
the stove again using the remote control;
• The stove switching on at the scheduled time will keep the same temperature and
power you set before you last switched it off;
• Please consider an interval of min. 20 minutes between the switching off and subse-
quent switching on of the stove. In this way the unit will have time to arrange a com-
plete cooling phase; in the event this minimal interval is not calculated, the stove will
not switch on as scheduled.
Program 1 (ON1 and OFF1)
Automatic switching on ON1
Please join the following procedure to set the time
for the automatic switching on according to the
program 1:
Press the key (1). You will see the hours and
minutes and the symbol ON1 blinking on the
remote control. Use the keys
change the wished time (intervals of 10 minutes).
To scroll the time faster, keep the keys
(3) pressed.
Confirm your selection pressing the key
once again.
You will now read the set switching on time on
the remote control. Press SEND (4) to transmit
your selection to the pcb of the stove.
The LED chrono-thermostat will light up on the
control board indicating that the programming is
on (5).
ON 1
2
3
(2) and (3) to
4
(2) and
1
(1)
5
AL C AL F
ON 1
4
2
3
1
64