Gear Selection; Magnet Detection - Walter Surface Technologies ICECUT300 Mode D'emploi

10) GEAR SELECTION
The ICECUT300 magnetic drill is fitted with a 2 speed gearbox. The gear is used to reduce the output speed when using
larger cutters.
Slide Selector Position
°
/\
\/
The ICECUT400 magnetic drill is fitted with a 4 speed gearbox. The gear is used to reduce the output speed when using
larger cutters.
Slide Selector Position
Left Right
/\
\/
\/ \/
/\ /\
/\
\/
Slide Selector Positon Left
The Slide Selector Positions show Left /\ and Right\/depicting an available range of 240 – 700/min.
11) MAGNET DETECTION
It is advised that when working on thin material a packing piece should be used to increase the material thickness
under the magnet. Working on thin material without a packing piece will reduce the magnet holding force.
It is advised that the drill is to be operated on ferrous material 12mm thick and above. Damage to the magnet base,
such as pitting, will affect the strength of the magnet holding force.
Speed Controller Setting
Level 1 Level 6
200/min 500/min
70/min 180/min
Speed Controller Setting
Level 1 Level 6
45/min 129/min
70/min 208/min
150/min 434/min
240/min 700/min
Slide Selector Position Right
11