Samsung DV48H7400E Série Mode D'emploi page 22

operating instructions, tips
digital graphic
2
display
dry level
3
selection button
temp selection
4
button
DV7000HA DRY_DV48H_USER MANUAL_DC68-03170J-08_EN.indd 22
SanItIZE – Sanitizes garments by infusing high temperature heat deep into
the fabric during the drying cycle. Use this cycle to keep your bedding and
curtains clean through sanitization.
DElIcatES – The Delicates cycle is designed to dry heat-sensitive items at a
low drying temperature.
toWElS (DV48(5)H7400E(G)*, DV45H7200E(G)*) – To dry bath towels and
similar items.
pErm prESS – Dry wrinkle-free cottons, synthetic fabrics, knits, and
permanent press fabrics automatically.
quIck Dry – Provides a 30 minute drying cycle.
tImE Dry – Time Dry allows you to select the desired cycle time in minutes.
Turn the Cycle Selector dial to Time Dry, and then press the Adjust Time up
arrow to set the drying time. Press the arrow repeatedly to scroll through the
time settings.
reFresh (DV48(5)H7400E(G)*) – Use to smooth out wrinkles and reduce
odors in loads of one to four items. In this cycle a small amount of water
is sprayed into the dryer drum after several minutes of tumbling with heat.
Confirm that the laundry load is dry.
aIr fluff (DV45H7200E(G)*) – The Air Fluff cycle tumbles the load at room
temperature air.
WrinKle aWay (DV48(5)H7400E(G)*) – Removes wrinkles from clothes
stored in closets, etc. It provides wrinkle release via optimized steam care.
For best results, load 2-3 items at once. You can extend the drying time by a
minimum of 20 minutes , depending on the item type or load. Confirm that the
laundry load is dry.
WrInklE rElEaSE (DV45H7200E(G)* / DV45H7000E(G)* ) – The Wrinkle
Release cycle will release wrinkles from items that are clean, dry, and only
slightly wrinkled, such as clothes from a crowded closet, suitcase or items that
have been in the dryer too long after the cycle has ended. Wrinkle Release can
be used with any temperature selection.
The display window shows the estimated time remaining in the cycle after
you have pressed the Start/Pause button. The estimated time remaining may
fluctuates as the cycle progresses.
The Drying light will illuminate and remain lit until the cycle is complete.
When your dryer is in the cool-down phase, the Cooling light will illuminate. When
your dryer is in the wrinkle prevent phase, the Wrinkle Prevent light will illuminate.
When the cycle is complete, "End" (DV48(5)H7400E(G)* / DV45H7200E(G)*) /
"0" (DV45H7000E(G)* will appear in the display panel until you push
the Start/Pause button or the Power button.
If your dryer is paused during a cycle, the indicator lights will blink until you press
the Start/Pause button.
To select the dry level in the Normal, Heavy Duty, or other Sensor Dry cycles,
press the Dry Level button. An indicator light will illuminate next to the dryness
level you selected.
Press the button repeatedly to scroll through the settings. Larger or bulkier
loads may require the Very Dry or More Dry setting for complete dryness.
Damp Dry is designed to partially dry items. Use for items that lay flat or hang
to dry.
To select the temperature for the load, press the Temp button. An indicator
light will illuminate next to the temperature you selected. Press the button
repeatedly to scroll through the settings.
High – For sturdy cottons or those labeled Tumble Dry.
medium – For permanent press, synthetics, lightweight cottons, or items
labeled Tumble Dry Medium.
low – For heat sensitive items labeled Tumble Dry Low or Tumble Dry Warm.
Extra low (DV48(5)H7400E(G)*, DV45H7200E(G)*) – Provides the lowest
heated drying temperature possible.
English - 22
2016/2/25 16:21:08