Assembly; Unpack Trash Pump; Add Engine Oil And Fuel; Attach Suction Hose - Briggs & Stratton HONDA VOX Industrial 073022 Manuel D'utilisation

Assembly

Your trash pump requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your trash
pump, please call the trash pump helpline at (800) 743-4115.
If calling for assistance, please have the model, revision, and
serial number from the data tag available. See Controls
section for data tag location.

Unpack Trash Pump

1. Remove the parts bag, accessories, and inserts
included with trash pump.
2. Open carton completely by cutting each corner from
top to bottom.
3. Ensure you have all included items prior to assembly.
Items in the carton include:
• Trash pump
• Oil bottle
• Parts bag (which includes the following):
• This operator's manual
• Engine operator's manual
• Owner's registration card
• Strainer basket and barb
• Hose barb (2)
• Barb cuff (2)
• Rubber seal (2)
• Hose clamp (3)
To prepare your trash pump for operation, you will need to
perform these tasks:
1. Fill out and send in registration card.
2. Add oil to engine crankcase.
3. Add fuel to fuel tank.

4. Attach suction hose.

5. Connect discharge hose (optional).
6. Move trash pump to safe operating location.
7. Prime the trash pump.
8. Locate strainer basket into water source.

Add Engine Oil and Fuel

• Place trash pump on a flat, level surface.
NOTE: Verify provided oil bottle is the correct viscosity for
current ambient temperature.
• Refer to engine operator's manual and follow oil and
fuel recommendations and instructions.
NOTICE
Any attempt to crank or start the engine before it has been
properly filled with the recommended oil will result in
equipment failure.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
NOTE: Check oil often during engine break–in. Refer to
engine operator's manual for recommendations.
Attach Suction Hose
You will need the following tool to install the hoses to the
trash pump:
• 1/4" or 6mm standard screwdriver
Connect Suction Hose to Pump
Use a commercially available hose. The suction hose must
be reinforced with a non-collapsible wall or braided material.
DO NOT use a hose with an inside diameter smaller than the
pumps suction port size.
1. Slide barb cuff (A) over hose barb (B). Insert rubber
seal (C) into end of barb cuff.
B
2. Screw hose barb assembly onto pump in clockwise
rotation until hose barb assembly is tightened securely.
A
C
7