Starting The Trash Pump; Stopping The Trash Pump - Briggs & Stratton HONDA VOX Industrial 073022 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Starting the Trash Pump

Use the following start instructions:
1. Make sure unit is on a flat, level surface and pump
chamber is primed.
2. Start engine according to instructions given in engine
operator's manual.
WARNING
Starter cord kickback (rapid retraction) can result
in bodily injury. Kickback will pull hand and arm
toward engine faster than you can let go.
Broken bones, fractures, bruises, or sprains
could result.
• When starting engine, pull cord slowly until resistance is felt and
then pull rapidly to avoid kickback.
WARNING
Contact with muffler area can result in serious
burns.
Exhaust heat/ gases can ignite combustibles,
structures or damage fuel tank causing a fire.
• DO NOT touch hot parts and AVOID hot exhaust gases.
• Allow equipment to cool before touching.
• Keep at least 5 feet (1.5 m) of clearance on all sides of trash
pump including overhead.
• Code of Federal Regulation (CFR) Title 36 Parks, Forests, and
Public Property require equipment powered by an internal
combustion engine to have a spark arrester, maintained in
effective working order, complying to USDA Forest service
standard 5100-1C or later revision. In the State of California a
spark arrester is required under section 4442 of the California
Public resources code. Other states may have similar laws.
12
IMPORTANT: It may take a few minutes for trash pump to
begin pumping water.
Pump output is controlled by adjusting engine speed.
Moving the engine speed lever in the "Max" (
will increase pump output, and moving the engine speed
lever in the "Min" (
) direction will decrease pump output.

Stopping the Trash Pump

1. Move engine speed lever to "Min" (
2. Turn engine off according to instructions given in
engine operator's manual.
) direction
) position.
BRIGGSandSTRATTON.COM

Publicité

Table des Matières
loading

Table des Matières