Renkforce D-3000 Notice D'emploi page 26

Manual operation:
• Push and hold the MANUAL (8) button on the remote control.
• The device emits fog at full fog volume (100%) as long as you keep this button pressed. Display:
Man 100%.
Continuous operation:
• Push the VOLUME (7) button on the remote control.
• The device emits continually with the fog volume set in the menu item "Volume OUT".
• Push the VOLUME (7) button again to switch off permanent operation again.
For permanent operation, the fog machine will occasionally interrupt fog bursts to heat up again,
depending on fog volume and ambient temperature.
Interval Mode:
• Push the TIMER (6) button on the remote control.
• The device will emit fog timer-controlledly now, with the values set in the menu items Duration Set, Inter-
val Set and Man Vol Out. The device will produce fog for the set time and then pause. Then the described
interval starts over.
• Push the TIMER (6) button again to switch off interval operation again.
DMX operation:
• Each DMX device in a DMX chain requires an assigned DMX channel to be clearly targeted by the con-
troller.
• Such DMX channel is defined by the DIP switches 1-9 (10) on the rear of the device. Each DIP switch is
assigned a value. The total of the assigned values then defines the assigned DMX channel.
The DIP-switch 10 has no function.
• The values of the individual DIP switches 1-9 can be taken from the table below. If a switch is in the "ON"
position, it is activated, while in the "OFF" position it is deactivated.
DIP switch DMX channel
1
2
3
4
5
6
7
8
9
26
1
2
4
8
16
32
64
128
256