Panasonic TC-L32G1 Manuel D'utilisation page 39

Automatically searches and adds available channels to the memory.
Select "ANT in"
Select Cable or Antenna.
Or select "Not used" (p. 16).
Select "Auto program"
ANT/Cable setup
ANT in Cable
Auto program
Manual program
Signal meter
Use this procedure when changing the channel setup or
changing the channel display.
Also, use this to add or skip channels from the channel
list manually.
You can select a channel tuning mode (Digital only/
Analog only) in "Channel surf mode"(p. 28)
Select "Edit"
Manual program
Edit Apply Cancel
Channel Caption Favorite Add
...
2 ... Yes
...
3 ... Yes
...
4 ... Yes
...
5 ... Yes
Select the item to be edited
Manual program
Edit Apply Cancel
Channel Caption Favorite Add
...
2 ... Yes
...
3 ... Yes
...
4 ... Yes
...
5 ... Yes
... Favorite
6 ... Yes •
...
7 ... Yes
Caption Add
...
8 ... Yes
... •
9 ... Yes
Select OK
RETURN
R Prev.page G Next page B Y
•
Proceed to
next page
Go back to previous page
To cancel the Edit
Manual program
Edit Apply Cancel
Channel Caption Favorite Add
...
2 ... Yes
...
3 ... Yes
...
4 ... Yes
...
5 ... Yes
Check the signal strength if an interference is found or freezing occurs on a digital image.
Signal meter
1-1
Channel
Tune manually
Signal strength
Signal intensity
Current 30%
Peak level 45%
If "Lock" (p. 36) is activated and "ANT/Cable setup" is selected, "Enter password." will be displayed.
next
select
select
next
select the item
to edit (Caption/
Favorite/Add)
next
Caption:
Changes the station identifier
Favorite:
Registers channel to Favorite
List
Add:
Adds or skips channels
select
next
change
or
channel
ok
Select a scanning mode
Auto program
All channels
Analog only
Digital only
After the scanning is completed, select "Apply"
(see below ).
All previously saved channels are erased.
Edit
Caption
Edit CH caption
Channel
80-101
---
Caption
OK
Change RETURN
G ABC → abc Y Delete
Caption
Select or edit the station identifier.
(maximum 7 characters available)
Favorite
Set favorite 1/3
26-1
1
2
Set favorite Select the number
Add
Press OK to select "Yes (add)" or "No (skip)"
Move cursor to channel number
Manual program
Edit Apply Cancel
Channel Caption Favorite Add
...
2 ... Yes
...
3 ... Yes
Select "Apply"
program
Apply Cancel
el Caption Favorite Add
...
... Yes
Changes will be lost. Continue?
Yes No
If the signal is weak, check the antenna.
If no problem is found, consult your local dealer.
Note
Not available if "Cable" is selected in "ANT in"
(see above).
Available only for digital antenna channels.
(p. 16)
ok
select
Settings are made automatically
select
change or
set/next
select
next
select
Press OK to tune
to the channel.
select "Apply"
ok
ok
(returns to "ANT/
Cable setup")
select "Yes"
39