Candy CD 374 SK Mode D'emploi page 25

Attention
This dishwasher is equipped with an anti-overflow safety device
which works even when power is switched off, and if the water
level is too high the supply will automatically be closed off.
Important
To ensure the correct operation of the anti-overflow safety
device, it is recommended not to move or to tilt the dishwash-
er during operation.
If it is necessary to move or to tilt the dishwasher, first make
sure the washing cycle is finished and that no water is left in
the tank.
Selecting the programme and special functions
Use in conjunction with programme guide
To set the programme, turn the dial clockwise until the pointer
( ) indicates the symbol of the required programme on the
control panel. Then press the On/Off button. Ensure that the
water supply is turned on and the door is closed properly.
"65°C" button
This button is an option available on the UNIVERSAL
INTENSIVE 65°C and DAILY INTENSIVE 65°C programmes
which will increase the temperature of the water of washing
from 50°C to 65°C.
Economy button
This button reduces the final heating of the water during the
last rinse. This activates a natural drying process, as with a
normal draining board, simply by leaving the door ajar at the
end of the cycle to enable the natural circulation of air. The "E"
button permits an energy saving of more than 20% and
shortens the cycle.
Recommended for evening washes when the dishes are not
required perfectly dry, immediately, straight after washing.
IMPORTANT:
When this button is selected, the programme finishes at
the "STOP " position on the programme dial.
48
Aquaprotect – Protected incoming water pipe
The main inlet pipe is contained within a protective transparent
hose. In the event of damage occurring to the main inlet pipe any
water leakage is retained within the transparent hose.
If water has leaked from the main inlet pipe there will be a visible
sign within the transparent hose.
You may continue to complete the programme cycle but for safety
we recommend the immediate replacement of the complete hose
assembly.
If the hose is not long enough for correct connection, it must be
replaced with a longer one.
The hose can be obtained from a Service Centre.
Protective
transparent
hose
Main inlet
pipe
49