Signs, Symbols And Abbreviations; Function; For Your Safety - WIKA WU-10 Mode D'emploi

Masquer les pouces Voir aussi pour WU-10:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. Signs, symbols and abbreviations / 4. Function / 5. For your safety

3. Signs, symbols and abbreviations

Potential danger of life or of
!
severe injuries.
Warning
Potential danger of life or
of severe injuries due to
catapulting parts.
Warning
Potential danger of burns
due to hot surfaces.
Caution
Notice, important informa-
tion, malfunction.

4. Function

Ultra High Purity Transducer
WU-10: Single End; WU-15: Flow Through; WU-16: Modular Surface Mount
Function: The pressure prevailing within the application is transformed into a standardised
electrical signal through the deflection of the diaphragm, which acts on the sensor element
with the power supply fed to the transmitter. This electric signal changes in proportion to the
pressure and can be evaluated correspondingly

5. For your safety

Select the appropriate transducer with regard to scale range, performance
!
and specific measurement conditions prior to installing and starting the
instrument.
Warning
Observe the relevant national regulations (e.g.: EN 50178) and observe the
applicable standards and directives for special applications (e.g. with
dangerous media such as acetylene, flammable gases or liquids and toxic gases or liquids
and with refrigeration plants or compressors). If you do not observe the appropriate
regulations, serious injuries and/or damage can occur!
4
WIKA Operating instructions/Betriebsanleitung/Mode d'emploi/Instrucciones de servicio WU-1X
The product complies with the appli-
cable European directives.
2-wire
Two connection lines are intended
for the voltage supply.
The supply current is the measure
ment signal.
3-wire
Two connection lines are intended
for the voltage supply.
One connection line is intended for
the measurement signal.
GB
5. For your safety
Open pressure connections only after the system is without pressure!
!
Take precautions with regard to remaining media in removed pressure
transmitter. Remaining media in the pressure port may be hazardous or
Warning
toxic!
Disconnect the instrument before connecting up to the power supply.
Make sure that all parts are protected against direct contact when installing
the device and making connections.
Configure the system with particular care when connecting up to other equipment.
Please make sure that the transducer is only used within the overload threshold limit all
the time!
Observe the ambient and working conditions outlined in section 7 „Technical data".
Ensure that the transducer is only operated in accordance with the provisions i.e. as
described in the following instructions.
Do not interfere with or change the transducer in any other way than described in these
operating instructions.
Remove the pressure transmitter from service and mark it to prevent it from being used
again accidentally, if it becomes damaged or unsafe for operation
Have repairs performed by the manufacturer only.
The operator is responsible for the material compatibility as well as correct handling,
operation and maintenance.
The safety of the user can be detrimentally influenced by the equipment if
e.g.: - visible damage is apparent
- it cannot be operated any longer as stipulated
- it has been stored over a longer period under unsuitable conditions.
In cases of doubt the device should be returned to the manufacturers for repair and
servicing.
Information about material consistency against corrosion and diffusion can be found in our
WIKA-Handbook, 'Pressure and Temperature Measurement'.
WIKA Operating instructions/Betriebsanleitung/Mode d'emploi/Instrucciones de servicio WU-1X
GB
5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Wu-15Wu-16

Table des Matières