Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Contents / Inhalt / Contenu / Contenido
Contents
Page 3-19
Inhalt
Seite 20-37
2
WIKA Operating instructions/Betriebsanleitung/Mode d'emploi/Instrucciones de servicio WU-1X
GB
D
GB
Contenu
Page 38-55
Contenido
Paginás 56-72
D
E
F
1. Important details for your information / 2. A quick overview for you
1. Important details for your information
F
Read these operating instructions before installing and starting the pressure transmitter. Keep
the operating instructions in a place that is accessible to all users at any time.
The following installation and operating instructions have been compiled by us with great care
but it is not feasible to take all possible applications into consideration. These installation and
operation instructions should meet the needs of most pressure measurement applications. If
questions remain regarding a specific application, you can obtain further information:
Via our Internet address www.wika.de / www.wika.com
„
„
The product data sheet is designated as PE 87.05
„
Contact WIKA for additional technical support (+49) 9372 / 132-295
With special model number, e.g. WU-10000, WU-15000 or WU-16000, please note specifica-
tions in the delivery note.
If the serial number on the product label gets illegible (e.g. by mechanical damage or repain-
ting), the retraceability of the instrument is not possible any more.
WIKA transducers are carefully designed and manufactured using state-of-the-art technology.
Every component undergoes strict quality and environmental inspection before assembly
E
and each instrument is fully tested prior to shipment. Our environmental management system
is certified to DIN EN ISO 14001. The finished instrument was tested, cleaned and carefully
packaged in a protective atmosphere prior to shipment.
Use of the product in accordance with the intended use WU-1X:
Use the transducer to transform the pressure into an electrical signal.
Knowledge required: Install and start the transducer only if you are familiar with the relevant
regulations and directives of your country and if you have the qualification required. You have
to be acquainted with the rules and regulations on hazardous areas, measurement and control
technology and electric circuits, since this transducer is „electrical equipment" as defined by
EN 50178. Depending on the operating conditions of your application you have to have the
corresponding knowledge, e.g. of aggressive media.
2. A quick overview for you
If you want to get a quick overview, read Chapters 3, 5, 7 and 11. There you will get some
short safety instructions and important information on your product and its starting. Read
these chapters in any case.
WIKA Operating instructions/Betriebsanleitung/Mode d'emploi/Instrucciones de servicio WU-1X
GB
3
Publicité
Table des Matières
