Bosch BSG8 Série Mode D'emploi page 16

en
6
Figure
a) Take the mains plug, pull the mains cable
to the required length and insert the plug
into a wall socket.
b)If your unit has an electronically actuated
cable rewind, the ready indicator will now
light up green.
7
Figure
To switch your vacuum cleaner on and off,
press the On/Off button in the direction of the
arrow.
8
Figure
The required suction power can be selected by
adjusting the suction regulator.
Low suction range:
For vacuuming delicate fabrics, e.g.
curtains.
Moderate suction range:
For daily vacuuming of lightly soiled floors.
High suction range:
For vacuuming durable floor coverings,
hard floors and for heavily soiled surfaces.
Vacuuming
You have bought an extremely powerful
device.
The highest suction setting is therefore only
recommended for heavily soiled, short-pile
carpets and hard floors.
9
Figure
Adjusting the floor tool:
For cleaning rugs
and carpets
For cleaning hard floors
Floor nozzle with carpet lifter*
10*
Figure
When you pull the floor tool backwards,
the rug is lifted, allowing you to clean
underneath its edge.
Vacuuming with accessories
Figure
Pull the combination tool in the direction of
the arrow to remove it from the tool holder.
a) Crevice nozzle
b)Upholstery nozzle
c) Furniture brush
Figure
=>
=>
* Depending on equipment level
11
For vacuuming in crevices and corners.
For difficult to reach places, the
combination tool can be extended to two
different lengths by pulling out the crevice
nozzle.
For either length extension, pull the crevice
nozzle out until you hear it engage.
The crevice nozzle can be pushed back in
again by releasing the telescopic locking
mechanism (pressing it in the direction of
the arrow).
For cleaning upholstered furniture,
curtains, etc.
For window frames, cabinets, profiles etc.
Fold the upholstery nozzle over in the
direction of the arrow.
To extend the brush ring, turn in the
direction of the arrow.
Before replacing the combination tool
in the tool holder, retract the brush
ring and fold the upholstery nozzle
back.
12*
When stopping cleaning for a moment, you
can use the parking aid on the back of the
vacuum cleaner.
Slide the plastic lug on the tool connector
into the groove at the back of the vacuum
cleaner.
If your cleaner has the automatic standby
function, it will now switch itself off.
=> Power indicator lights up "green".
11