Table des Matières
Publicité
2
Figure 8
Page -20 -
1
2
HOW TO OPERATE THE MACHINE
How To Start/Stop The Machine
WARNING:
The switch to start and stop the machine is activated
by the interlock switch (1) and the levers (2) under the
handle grips. See figure 8.
To start the machine, follow this procedure:
1. Lower the handle
2. Lock the handle in the best position for operation.
NOTE: Make sure you hold the handle with both
hands.
3. Push the interlock switch (1), and apply pressure to
the levers (2). See figure 8.
How To Control The Machine
NOTE: Sanding operations create higher torque
conditions than normal floor polishing. Make sure
you firmly grip the handle with both hands.
The side to side movement of the machine is controlled
by raising the handle and pressing down on the handle.
To move the machine to the left, press down on the
handle slightly. To move the machine to the right, raise
the handle slightly.
MAINTENANCE
WARNING: Maintenance must be done
Maintenance Instructions
Return the machine to a Clarke American Sanders
Authorized Service Location every 12 months for main-
tenance inspections.
American Sanders Operator's Manual - Sander 1600 120V
®
Clarke
Never start machine when the
handle is in the vertical posi-
tion.
by authorized personnel
only.
Publicité
Table des Matières
