Guarantee - Dometic COOLAIR 9100300072 Instructions De Montage

CoolAir SP950C
Fit the fastening frame and the CoolAir SP950 parking cooler on the Volvo FH as
follows:
I
NOTE
Only install the condenser unit after you have attached the mounting
frame on the rear wall of the truck.
➤ Insert and tighten the four M8 x 35 bolts, eight U washers M8 8.4 x 16 mm and
four M8 retaining nuts (fig. 1, page 2) in the mounting frame for the condenser
unit.
➤ Remove all four M8 nuts and M8 8.4 x 16 mm U washers from the side spoiler
fastening (fig. 2 1, page 3).
A
NOTICE!
Secure side spoiler from falling.
➤ Place the fastening frame onto the M8 bolts and attach using the M8 nuts and
M8 8.4 x 16 mm U washers provided (fig. 2 1, page 3).
➤ Put the the four large M8 8.4 x 24 mm U washers as spacer discs onto the pro-
truding screws on the fastening frame (fig. 2 2, page 3).
➤ Place the condenser unit on the projecting bolts of the mounting frame and bolt
to the four U washers M8 8.4 x 16 mm and four M8 retaining nuts (fig. 3,
page 3).
➤ Check that all bolts are still tight after travelling approximately 200 km.
7

Guarantee

The statutory warranty period applies. If the product is defective, please contact the
service partner in your country (addresses on the back on the instruction manual).
Our experts will be happy to help you and will discuss the warranty process with you
in more detail.
EN
Guarantee
7