Nap Alarm - AEG MRC 4121 Mode D'emploi

Nap alarm

The nap alarm can be used for e.g. a short "nap". The function only operates in standby.
• Press the MEM.SET /NAP/M+ button repeatedly (1) to select the time after which the
device will beep. Select from 90 to 10 minutes or OFF in steps of 10 minutes.
• After the selected time has elapsed, an increasingly fast beep will sound. Use the
button (9) to turn off the beep.
Projection
With this unit, you can project the time onto a wall or the ceiling.
• You can switch this function on and off with the ON/OFF / PROJECTION button (24).
• Rotate the projector (20) to the desired position.
• The rear of the projector has a setting wheel (22) with which you can adjust the sharp-
ness of the projection.
• You can use the 180° FLIP button (23) to flip the projection by 180 degrees.
Cleaning
CAUTION:
Do not dip the appliance in water.
• Remove the plug before cleaning.
• Clean the appliance with a slightly humid cloth without any additives.
Trouble-shooting
Problem
The unit cannot be
operated
Cause
The unit is blocked and
"hangs"
English
Solution
Press the RESET button (see page 71
"Restore factory defaults"). The settings
made thus far will be lost.
75