Remote Control; Getting Started; Inserting Batteries Into The Remote Control (Cdp-Ce375 Only); Hooking Up The System - Sony CDP-CE375 Mode D'emploi

Getting Started

Inserting Batteries Into
the Remote Control (CDP-
CE375 only)
You can control the player using the supplied
remote.
Insert two R6 (size AA) batteries by matching
the + and – on the batteries to the diagram
inside the battery compartment.
Insert the negative (–) end first, then push in
and down until the positive (+) end clicks into
position.
When using the remote, point it at the remote
sensor on the player.
Tip
When the remote no longer operates the system,
replace both batteries with new ones.
Note
• Do not leave the remote near an extremely hot or
humid place.
• Do not drop any foreign object into the remote
casing, particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
• If you don't use the remote for an extended period
of time, remove the batteries to avoid possible
damage from battery leakage and corrosion.
6
US

Hooking Up the System

Hookups
This section describes how to hook up the CD
player to an amplifier. Be sure to turn off the
power of each component before making the
connections.
ANALOG OUT
ANALOG
(White) (L)
OUT
(Red) (R)
Audio input
Audio input
(Red) (R)
(White) (L)
: Signal flow
Tip (CDP-CE375 only)
You can adjust the analog output level to the
amplifier using the remote comes with this player.
Press ANALOG OUT LEVEL +/– on the remote.
You can reduce the output level up to –20 dB.
When you reduce the analog output level, "FADE"
appears in the display.
When you turn off the player, the analog output level
automatically returns to the maximum level.
CD player
To mains
Amplifier
To mains