Selecting A Location - Truma Mover SR Version 2 Mode D'emploi

Figure 11
If this installation kit is used in Germany, acceptance
by a vehicle expert is required.
5. AL-KO Vario III / AV installation kit
Essential for caravans with AL-KO Vario III / AV chassis
(frame thickness less than 2.8 mm),
part no. 60010-21500.
Figure 12
6. AL-KO Chassis M adapter kit for chassis with axial
displacement with a permitted gross weight of 1800 kg
Mounting set for compensating for frame edges for caravans
with AL-KO Chassis M. Mounting set is needed for mounting
in front of the axle,
part no. 60030-38600.
Figure 13
7. AL-KO Chassis M adapter kit for chassis with a continu-
ous frame and a permitted gross weight of 1900 kg to
2000 kg
Mounting set for compensating for frame edges for cara-
vans with AL-KO Chassis M. The mounting set is needed for
mounting in front of the axle,
part no. 60031-02000
Figure 14
8. Mover® mounting set for Eriba-Touring
Part. no. 60030-09000
Figure 15
In some cases installation is not possible because of the
design of the sub-frame. Contact your dealer if necessary.
20
9. Eriba-Troll mounting set
part. no. 60031-03000
The Eriba Troll mounting set allows the Mover® to be mounted
behind the axle on an Eriba Troll caravan / trailer.
Figure 16
10. Short mounting system
Replacement for standard mounting system if this cannot be
used due to lack of space and to compensate for the height
(30 or 60 mm) of substructures such as tanks.
part. no. 60031-20000
Figure 17
11. Mud guard set (no illustration)
Replacement for the standard mud guards, if these cannot be
adapted to the Mover®.
part. no. 60031-08200
In some cases installation is not possible because of the
design of the sub-frame. Contact your dealer if necessary.
Detailed installation instructions are included with each
mounting set.
The Mover® SR must not be fitted to caravans /
trailers with other frames.
The vehicle frame must not be drilled (unless using the low
chassis kit* and the Eriba Touring mounting set) or welded.
Wheel suspension parts must not be removed under any
circumstances.
* In the case of the AL-KO Vario III / AV chassis, the vehicle
frame must under no circumstances be drilled into even if
the low chassis kit is used.

Selecting a location

The Mover® should preferably be mounted in front of the axle,
but in exceptional circumstances (e.g. lack of space) it is also
possible to mount it behind the axle. Only use the bolts pro-
vided (or the mounting parts available as special accessories)
to attach the Mover®.