Troubleshooting; Tuning The Electronic Control Unit To The Radio Remote Control; Declaration Of Conformity; Technical Data - Truma Mover SR Version 2 Mode D'emploi

Troubleshooting

Before calling customer service, please check the following:
Are the batteries in the remote control in perfect condition?
Is the caravan battery in perfect condition and fully charged?
Please note that battery performance can deteriorate consid-
erably at cold ambient temperatures.
Perform a reset by disconnecting the battery briefly (approx.
10 seconds).
If these actions do not remedy the problem, please contact
Truma Service.
Tuning the electronic control unit to the radio
remote control
The remote control and the control unit are tuned to
each other in the factory.
If the control unit or the remote control is replaced, they must
be tuned to each other again in accordance with the instruc-
tions below.
Check that installation has been carried out in accordance
with the installation instructions, and make sure that the drive
rollers are not engaged. Check that the battery is properly
connected and in good condition, and that the control unit is
being supplied with 12 V.
Press and hold the reset button (k) on the control unit
(red LED – j – flashes slowly), and after approx. 5 sec the
LED (j) flashes rapidly. Release the reset button and within
10 sec press and hold button (c) – caravan reverse – on the
remote control, at the same time switching the remote con-
trol on using the slide switch (a).
j
k
Figure 4
The remote control and the control unit are now tuned to each
other. Once tuning is complete, the red LED flashes fast.

Declaration of conformity

1. Information about the manufacturer
Name:
Address:
2. Device identification
Type / model:
Manoeuvring Assistant Mover® SR
3. Complies with the requirements of the following
EC directives
3.1 R&TTE directive (1999/5/EC)
3.2 EMC directive (2004/108/EC)
3.3 Radio interference suppression in motor vehicles
3.4 Low Voltage Directive 2006/95/EC
3.5 End-of-life vehicle directive (2000/53/EC)
and bears the type approval number e1 03 4473and the CE mark.
Mover® SR:
Class 1, frequency 868 MHz.
Countries:
AT, BE, BG, CH, CY, CZ, DE, DK, EE, ES, FI, FR, GB, GR, HU,
IE, IS, IT, LT, LU, LV, MT, NL, NO, PL, PT, RO, SE, SI, SK.
4. Basis of the proof of conformity
EN300220-2:2006, EN300220-1:2006 (R&TTE art. 3.2),
EN301489-1:2005, EN301489-3:2002 (EMC art. 3.1b),
EN61000-4-2:2001, EN61000-4-3:2006, EN61000-4-6:2001,
EN55022:2003 (Class B), ISO 7637-2:2004, EN60950:2001,
2004/104/EC, 2005/83/EC, 2006/28/EC, 2000/53/EC
5. Monitoring body
Federal Motor Transport Authority (Kraftfahrt-Bundesamt)
a
6. Signatory details
c
Signature: Mathias Venschott
Product Centre Manager
Air Conditioning and
Manoeuvring Systems

Technical data

Designation
Mover® SR
Deployment range
Single-axle caravans with a gross weight of up to 2000 kg
Operating voltage
12 V DC
Power consumption
Approx. 20 A on average
Maximum 120 A
Quiescent current consumption
< 20 mA
Remote control frequency
Class 1, 868 MHz
Speed
Approx. 16 cm per second (depending on weight and slope)
Weight
Approx. 34 kg
(including cross actuation device)
Truma Gerätetechnik GmbH & Co. KG
Wernher-von-Braun-Str. 12, D-85640 Putzbrunn
72/245/EEC (with supplements)
Subject to technical changes.
Putzbrunn, 22.04.2013
17