Operating Features - Urmet 1092 Manuel D'utilisation

OPERATING FEATURES

PUSH BUTTON TO ACCESS
TO THE MENU ALONG THE
CAMERA CABLE
TO SELECT THE VIDEO OUTPUT
The 1092/272 camera may use 3 different video outputs, which are on the same BNC
connector:
High-definition AHD (Analog High Definition) video output
•
CVBS standard interlaced video output
•
Video output in COMET mode
•
If pressing the menu access button to the RIGHT for a few seconds, you can select the AHD
video output. If pressing it for a few seconds to the LEFT, you can select the CVBS video
output.
PAL e NTSC standards can be selected, besides from the OSD menu and for all video outputs,
pressing the menu access button to DOWN for a few seconds. The command works in toggle,
selecting alternatively PAL and NTSC.
You can enter the COMET video mode if you select an OSD menu item and if the video signal
is in CVBS (ADJUST menu).
NOTE: COME option is available only with the CVBS video output.
The presence or absence of this option therefore permits to identify if the camera is using the
CVBS or AHD video output.
ATTENTION: case of missing video on the connected device (monitor or DVR), verify
that the selected video output matches with the one selected on the device
In case of missing images in a DVR with AHD and CVBS inputs, try the following
steps:
1. Leave a single camera connected to the channel 1 of the DVR
2. Press the button for few seconds to right and left until the image appears on
the screen
3. If case of missing image again, press the button to down verify the type of
input selected on the DVR menu
20
UP
LEFT SET
DOWN
RIGHT
DS1092-186