Urmet 1092 Manuel D'utilisation page 28

Option
SELECT
DISPLAY
SENSITIVITY
WIDTH
COLOR
TRANS
ALARM
DEFAULT
ALARM - ALARM MOTION MANAGEMENT
VIEW TYPE
OSD VIEW
ALARM OUT
ALARM SIG.
TIME
RETURN
In the ALARM submenu you can configure the alarm specification the operator can display if a movement
happens in the previously sensitised area(s). Available options if enabling the VIEW TYPE function: ALL
(displays the box and the frame), OUTLINE (displays the frame only), BLOCK (displays the box only). The
OSD VIEW option displays an alarm message too. The ALARM OUT, ALARM SIG. and TIME options are
not enabled in this camera.
PRIVACY – MASKING ONE OR MORE ZONES OF THE SCENE
The PRIVACY function allows to define up to 4 privacy zones that mask specific areas. A privacy zone is
displayed on the monitor as a rectangle, with perimeter, dimensions, colour and transparence level
previously set by the user.
REMARKS ON PRIVACY ZONE
It is suggested to use privacy zones lightly bigger than areas to be masked.
•
Privacy zones can only be rectangular.
•
Select this option to activate (ON) the privacy zones and access the following submenu.
28
Value
AREA1 ÷ AREA4
ON ÷ OFF
0 ÷ 100
000 ÷ 013
RED ÷ GREEN ÷
BLUE ÷ WHITE
0.25 ÷ 1
/
/
ALARM
ALL
ON
ON
HIGH
■■█■■■■■■4
RET
The scene is split up into areas that can be activated by
the user. Select each area to be set and confirm with the
option DISPLAY (see below)
Select this option to enable (ON) or disable (OFF) motion
detection for previously selected areas.
This function allows to increase or decrease the motion
detector sensitivity.
Use the camera joystick to select a value from 0 (low
sensitivity) and 100 (high sensitivity).
This function allows to define the width of the selected
area.
This function allows to define the perimeter color of the
selected area
Not available
Alarm motion signals management (see below)
It allows to restore the default settings.
Description
DS1092-186