Amana ADB-2 Guide D'utilisation Et D'entretien page 10

Cycles, Options and Lights
Lights/Display
INDICATOR
Time Remaining Display
(select models)
Clean
(select models)
Drying
(select models)
Washing
(select models)
Heating Delay
(select models)
Sanitized
(select models)
On
Notes
• When Sanitize (select models) is selected, cycles are monitored to assure sanitization. The Sanitized light will not
activate if sanitization requirements are not met. This could happen if the cycle is interrupted, power failure occurs or
incoming water temperature is below 120° F (49° F).
• The Clean and Sanitized indicator lights (select models) will not relight after a power failure until after the next cycle is run.
(select models)
Shows approximate minutes remaining in a cycle. The symbol "2H" will appear when cycle time
is greater than 99 minutes. Cycle times shown in the numerical display (select models) will
increase or decrease, based on each load's soil level, water temperature and selected options.
Illuminates at the end of the cycle and remains lit until the door has been open for 30 seconds
continuously.
Illuminates during the entire dry period and goes out when the cycle is completed.
Illuminates during all rinse and wash portions of the cycles.
Illuminates when cycle is being extended to heat the water.
Illuminates at the end of the cycle when conditions have been met to achieve sanitization. The
light will remain lit until the door has been open for 30 seconds continuously.
Illuminates during all rinse, wash and dry portions of the cycle and goes out when the cycle is
completed.
DESCRIPTION
9