Hex Wrench Storage - Makita JR103D Manuel D'instruction

1
► 1. Recipro saw blade 2. Hex wrench 3. Hole for
recipro saw blade 4. Blade clamp
To install the recipro/jig saw blade, loosen the bolt by
hex wrench. When installing a recipro saw blade, press
the bolt with the hex wrench to open the slot during
inserting the blade.
1
► 1. Recipro/jig saw blade 2. Blade clamp 3. Hole for
recipro saw blade 4. Hole for jig saw blade
You can use both jig saw blades (B type) and recipro
saw blades according to your work. Insert the recipro/
jig saw blade straight into the blade clamp and tighten
it by hex wrench. Pull the recipro/jig saw blade lightly to
make sure that the recipro/jig saw blade does not fall off
during operation.
To remove the recipro/jig saw blade, follow the installa-
tion procedure in reverse.

Hex wrench storage

1
► 1. Hex wrench 2. Protrusion
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
OPERATION
CAUTION:
Always press the shoe firmly
against the workpiece during operation. If the
shoe is removed or held away from the workpiece
during operation, strong vibration and/or twisting will
be produced, causing the blade to snap dangerously.
CAUTION:
Always wear gloves to protect
your hands from hot flying chips when cutting
metal.
CAUTION:
Be sure to always wear suitable
eye protection which conforms with current
national standards.
CAUTION:
Always use a suitable coolant
(cutting oil) when cutting metal. Failure to do so will
cause premature blade wear.
7 ENGLISH
2