Medisana LT 480 Mode D'emploi page 24

4 Miscellaneous
GB
4.4
Trouble-
shooting
4.5
Replacing
the lamp
tubes
20
Problem Possible cause
No light Device is switched off
No power connection
On average, the fluorescent lamps need to be changed after ap-
proximately 8000 hours' use. If a lamp fails, it must be replaced. In
order to change a fluorescent lamp, the appliance must be disas-
sembled. Have the lamps changed by your specialist dealer, an au-
thorised service centre or a qualified specialist to prevent damage
to the appliance.
Solution
Use On-/Off-switch
to switch it on
3
Check mains adaptor
and power cable