Battery Information; Battery Protection; Battery Charging - patura P 100 Mode D'emploi

Masquer les pouces Voir aussi pour P 100:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation
1 Connect the Fence earth terminal to a separate earth sys-
tem that is at least 10 m away from other earth systems.
2 Connect the Fence output terminal to the fence.
3 Connect the energiser to a 12 V battery using the
battery leads supplied. Attach the + (red) clip to the
positive terminal of the battery, and the – (black) clip to
its negative terminal.
4 To prevent damage caused by livestock or bad weather,
house the battery and the energiser in protective enclosures.
Mounting the energiser
The energiser can be mounted directly onto a steel Y-post or
T-post using the mounting slot in the rear of the housing.
To mount onto a wooden post, use two 75 mm nails or
screws and two washers.
Thread the washers onto the
nails or screws. Space the nails
or screws 75 mm apart . Drive
in the nails or screws, allowing
them to protrude by 10 mm.
Slide the energiser onto the
nails with the washers inside
the mounting slot.
14
Operation
1. Connect the energiser to a 12 V battery.
2. The indicator light flashes each time the
energiser pulses.

Battery information

Use a 12 V rechargeable sealed lead-acid battery.
Do not dispose of the battery in a land-fill or in a fire.
In the event of a spill or leakage from a sealed
lead-acid battery:
• Contain small spills with dry sand, earth or vermiculite. Do not
use combustible materials. If possible, carefully neutralise spilled
electrolyte with soda ash, sodium bicarbonate, lime, etc.
• Wear acid-resistant clothing, boots, gloves and a face shield.
• Do not let un-neutralised acid get into the sewage system.
• Neutralised acid must be managed in accordance with
approved local, state and federal requirements. Consult your
state environmental agency and/or federal EPA.

Battery protection

To ensure the battery remains in good condition,
the energiser will automatically turn off once the
battery is flat. The energiser will restart once the
battery has been recharged or replaced.

Battery charging

Warning!
-
Do not attempt to recharge a non-rechargeable battery.
-
When recharging a battery, ensure that there is adequa-
te ventilation to allow gases to disperse.
Regular recharging of the battery is essential.
Use a suitably rated battery charger and refer to
the battery manufacturer's recommendations.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

P 200P 300146100146200146300

Table des Matières