Velleman HQLP10022 Mode D'emploi page 8

Damage caused by disregard of certain guidelines in this manual is not covered by the
warranty and the dealer will not accept responsibility for any ensuing defects or
problems.
Nor Velleman nv nor its dealers can be held responsible for any damage (extraordinary,
incidental or indirect) – of any nature (financial, physical...) arising from the possession,
use or failure of this product.
Keep this manual for future reference.
4. Installation
4.1 General Guidelines
Have the device installed by a qualified person, respecting all applicable norms.
Install the device on an even, fire-resistant, scratch-resistant, water-resistant and non-
slippery surface.
The carrying construction must be able to support 10 times the weight of the device for
1 hour without deforming.
Make sure there is no flammable material within a 1 m radius of the device.
Install the device in a location with few passers-by that is inaccessible to unauthorised
persons.
Install the device in a location where you can easily access the power cord.
4.2 Overhead Installation
When hung, the device must always be secured with a secondary attachment e.g. a
safety cable (not incl.).
Never stand directly below the device when it is being mounted, removed or serviced.
Have a qualified technician check the device once a year and once before you bring it
into service.
Overhead mounting requires extensive experience: calculating workload limits,
determining the installation material to be used... Have the material and the device itself
checked regularly. Do not attempt to install the device yourself if you lack these
qualifications as improper installation may result in injuries.
For truss mounting, use an appropriate clamp (not incl.) and fit an M10 bolt through the
centre of the (folded) bracket.
V. 02 – 15/06/2018
HQLP10022
8 ©Velleman nv