Components; Important - Applied Comfort EA Série Mode D'emploi Et D'installation

COMPONENTS --- COMPOSANTES
Heating Cooling Chassis -- Châssis du chauffage et de climatisation
Outside Surface of Finished Wall --- Surface extérieure d'un mur fini
Outdoor Louver --- Déflecteur extérieur
Inside Surface of Finished Wall ---Surface intérieure d'un mur fini
Front Panel --- Panneau avant
Cabinet/Wall Sleeve --- Caisson de ventilation/ boîtier-manchon
1. Cabinet/Wall Sleeve
The cabinet is to be built into the wall during construction, as it serves as a wall sleeve. The one size cabinet/wall
sleeve is used for all wall thicknesses from 2" through 12" maximum. For walls thicker than 12", a cabinet
extension is required. For installation of wall sleeve extensions, see instructions packed with the extensions.
2. Heating/Cooling Chassis
This chassis includes all cooling components, air moving components and controls.
3. Power Supply Cord and Plug
A power supply cord with a 15A, 20A, 30A male plug extends from the control section of the unit, on the right hand
side. This cord is to be attached to a field furnished and mounted receptacle in the(optional sub base), on the
right of the unit.

4. IMPORTANT!

After installation of the cabinet/ wall sleeve, the sleeve should be thoroughly cleaned. The chassis should be
installed and the front panel put in place. The room-side portion of the cabinet should be carefully protected
during the construction period to prevent scratching of the paint. The heating/cooling unit must not be used for
temporary heating or cooling during the building's construction stage.
-- -- -- -- --
2