Cleaning The Scanner - Epson TM-S2000MJ Manuel De L'utilisateur

English
Cleaning the MICR Head
When the MICR head becomes dirty, the product cannot read the magnetic ink characters
normally.
Clean the MICR head every 6 months or every 100,000 passes by setting the following
cleaning sheet in the same way as cut sheet paper. (See "Inserting Cut Sheet Paper" on
page 16.)
KIC Team, Inc.
• Waffletechnology
• Epson Check Scanner Cleaning Kit (model:KWEPS-KCS2)
Note:
Use a cleaning sheet only one time; then discard it.
It is recommended to clean the MICR head once per week or once every 2,000 sheets for good
reading results.
It is recommended to clean the scanner after cleaning the MICR head.

Cleaning the Scanner

If the glass of the scanner gets soiled from ink or paper dust, the quality of scanned data
may deteriorate. Clean the glass every 6 months or every 100,000 passes by following the
steps below.
Note:
It is recommended to clean the scanner once per week or once every 2,000 sheets for good
reading results.
1. Pull the scanner cover open lever and open the scanner cover by pulling it outward.
(See illustration J.)
Lightly wipe 2 parts of glass areas (see illustration K) with a soft, dry cloth.
2.
CAUTION:
Do not use synthetic detergent, benzine, water, or other liquid for cleaning. Doing so may
result in a stain.
When the glass of the scanner is smeared with oil, grease or other unremovable substance,
wipe it with a cloth lightly dipped in alcohol. However, never apply any liquid directly to the
glass of the scanner.
3. Close the scanner cover firmly until it clicks in place.
Troubleshooting
Error LED is on or flashing
❏
Make sure that all the covers are properly closed.
❏
When the Ink LED is on, see "Installing and Replacing the Ink Cartridge" on page 14
to replace the ink cartridge with a new one.
❏
When paper or an ID card is jammed, remove the jammed paper referring to "Paper
or ID card is jammed."
❏
Printing stops if the surroundings of the print head overheats, and resumes
automatically when it cools.
❏
Turn off the product, and after 10 seconds, back on. If the Error LED is still flashing,
the product may require servicing.
18 TM-S2000MJ User's Manual
®
MICR cleaning card (model:CS1B15WS)