98
E
SETTING THE BEEP SOUND
How to set the beep sound (Audible feedback)
Press and hold the Flash mode button and open the lens
barrier at the same time.
If you hear a single beep, the beep sound is set to ON.
If the camera makes no sound, the beep sound is set to
OFF.
Note:
The beep sound setting is not affected when the
batteries are unloaded.
SELFTIMER
1
Press the Selftimer button. The Selftimer indicator is
displayed on the control panel.
Use a tripod to hold the camera securely.
2
Aim at your subject, and press the Shutter release button.
The shutter will be released about 12 seconds after the
Shutter release button is pressed. (The Selftimer signal
lights for 10 sec. and blinks for 2 sec.)
Note:
The Selftimer is disengaged when the shutter is
released.
To cancel the Selftimer after it has been
activated, press the Selftimer button again or
close the lens barrier.