Cleaning And Storage - Mr. Magic Z 09745 Mode D'emploi

EN
9. Turn the blending container over and screw the cross-blade adapter off.
10. Clean the accessories immediately after each use to prevent the formation of germs
(see chapter "Cleaning and storage"). Do not allow any residual food to dry onto it.

Cleaning and storage

ATTENTION!
■ Danger of electrocution! Prior to each cleaning, pull the mains plug out of the socket.
■ Danger of electrocution! Keep the motor unit, mains cord and plug away from water
or other liquids! Never touch them with wet hands. The motor unit is not suitable for
cleaning in the dishwasher.
■ Risk of injury associated with sharp blades! Be very careful when handling the
cross-blade adapter. The cutting blades are extremely sharp. Never touch the blades
with your bare hands. When removing, inserting or cleaning the cross-blade adapter,
always hold it by the plastic housing.
■ The surfaces could be damaged! Do not use any scouring or abrasive cleaners or
scouring sponges to clean the device.
The cross-blade adapter, blending container and lid are suitable for cleaning in
the dishwasher.
• Immediately clean the device and accessories after use to prevent the formation of
germs:
1. Ensure that the device is disconnected from the mains supply!
2. Clean the accessory parts used (cross-blade adapter, blending container and lid) with
clean, warm water and a small amount of mild detergent or in the dishwasher.
3. If necessary, wipe the motor unit off with a damp cloth. Dry it off with a soft cloth.
4. Let all parts dry completely before reassembling them.
5. Store the device in a clean, dry area that is not accessible to children and animals.
NOTE: The plastic parts may discolour with time. However, this is of no concern with
respect to health or the functioning of the device parts.
18
4. Turn the blending container upside down and place the cross-
blade adapter in the motor unit. The 3 catches on the blend-
ing container must be inserted in the corresponding recesses
in the motor unit for this.
5. Connect the mains plug to a properly installed, easily acces-
sible socket.
6. Switch the device on. To do so, gently push the blending con-
tainer down and, at the same time, turn it clockwise until it
locks into place. Always hold the motor unit fi rmly with one
hand during preparation!
7. To switch the device off, turn the blending container counter-
clockwise up to the stop.
8. Wait until the blades have come to a complete stop. Then
remove the blending container.