Cleaning And Storage; Troubleshooting - Mr. Magic Z 03024 Mode D'emploi

Cleaning and storage

ATTENTION!
■ Danger of electrocution! Prior to each cleaning, pull the mains plug out of the socket.
■ Danger of electrocution! Keep the motor unit, mains cord and plug away from water
or other liquids! Never touch them with wet hands. The motor unit is not suitable for
cleaning in the dishwasher.
■ Risk of injury associated with sharp blades! Be very careful when handling the
cross-blade adapter. The cutting blades are extremely sharp. Never touch the blades
with your bare hands. When removing, inserting or cleaning the cross-blade adapter,
always hold it by the plastic housing.
■ The surfaces could be damaged! Do not use any scouring or abrasive cleaners or
scouring sponges to clean the device.
The cross-blade adapter, blending container and the lids are suitable for cleaning
in the dishwasher.
• Immediately clean the device and accessories after use to prevent the formation of
germs:
1. Ensure that the device is disconnected from the mains supply!
2. Clean the accessory parts used with clean, warm water and a small amount of mild
detergent or in the dishwasher.
3. If necessary, wipe the motor unit off with a damp cloth. Dry it off with a soft cloth.
4. Let all parts dry completely before reassembling them.
5. Store the device in a clean, dry area that is not accessible to children and animals.
NOTE: The plastic parts may discolour with time. However, this is of no concern with
respect to health or the functioning of the device parts.

Troubleshooting

If the device is not working properly, please check whether you are able to rectify the
problem yourself fi rst.
Do not attempt to repair a defective device yourself!
If you are unable to switch the device on, check the following:
• Is the mains plug properly connected with the socket?
• Is the socket defective? Try another socket.
• Was the fuse for your mains connection triggered?
• Has the blade adapter been correctly screwed onto the blending container?
• Is the blending container correctly fi tted in the motor unit? The device can only be
activated if the blending container has been properly fi tted in the motor unit and has
locked in place.
03024_DE-GB-FR-NL_A5_V2.indb 17 03024_DE-GB-FR-NL_A5_V2.indb 17
17 EN
14.01.2016 13:35:02 14.01.2016 13:35:02