Evaluations; Parameter Settings - SoFlow SO FAR SO FREE Flowboard Air Aluminium Manuel D'utilisation

4.4 Evaluations

If you press the power-button briefly, the display will show a variety of information.
Following letter combinations on the display stand for:
 "DIS" current trip's distance driven
 "ODO" total distance driven (mileage counter)
 "RPM" current number of revolutions
 "TIME" current trip's duration
 "VOL" battery voltage in volts
The respective figures can be displayed in this order by pressing the power-button multiple times. Please note that the value
for each trip's distance (DIS) and duration (TIME) will be reset every time you turn off the device.

4.5 Parameter settings

Your newly bought Flowboard Air has already preset all the important parameters. Please don't change those settings unless
you have the necessary knowledge.
If you press and hold the two buttons on the top and bottom on the left side of the display, you'll start the programming
function of your Flowboard Air. A short press of the power-button will show the following parameters:
 P0: setting of undervoltage – default value of 21.5
 P1: setting of wheel diameter – default value of 08
 P2: setting of engine-magnetic pole ratio – default value of 09
 P3: setting of speed test signal – default value of 001
copyright by www.so-flow.com 21
Flowpad Bedienungsanleitung
User Manual