Briteq MEGA-STROBE 1500 STD Mode D'emploi page 6

ENGLISH
OPERATING INSTRUCTIONS
 Regular breaks during operation are essential to maximize the life of this device as it is not designed for
continual use.
 The units' surface temperature may reach up to 85°C. Don't touch the housing with bare-hands during its
operation.
 Always unplug the unit when it is not used for a longer time or before replacing the bulb or start servicing.
 In the event of serious operating problems, stop using the fixture and contact your dealer immediately.
 Important: Never look directly into the light source! Don't use the effect in the presence of persons
suffering from epilepsy.
Manual operation:
 Connect the device to the mains.
 Turn the flash speed button to adjust the flash speed.
Operation via a Remote Controller:

Connect the Signal Input of the strobe with the Signal output of the controller (ex. FL-01C or FL-34C)
via a mono signal cable with ¼" mono Jack connectors.

If desired, you can also connect more than one strobe. Just connect the Signal Output of your first
strobe with the Signal Input of the next one. Use again a mono signal cable with ¼" mono Jack
connectors.

Set all the control knobs to the OFF position (no flash)

Refer to the user manual of your strobe controller to learn how to control the strobes.

Connect all the items to the mains
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
 The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics.
 Clean with a soft cloth using normal glass cleaning products.
 Always dry the parts carefully.
 Clean the external optics at least once every 30 days.
 Clean the internal optics at least every 90 days.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
SPECIFICATIONS
Mains Input:
Power consumption:
Fuse:
Lamp:
Size:
Weight:
You can download the latest version of this user manual on our website: www.beglec.com
BRITEQ
®
Every information is subject to change without prior notice
AC 220-240V, 50Hz
1500 Watt
250V 16A
ST2000
460 x 125 x 220cm
3 kg
4/24
OPERATION MANUAL
MEGA STROBE 1500