5/ Use - Selecline 600081547 Manuel D'utilisation

Climate class
SN
N
ST
T
Electrical connection
Before plugging in, ensure that the voltage and frequency shown on the rating plate
correspond to your domestic power supply. The appliance must be earthed. The power supply
cable plug is provided with a contact for this purpose. If the domestic power supply socket is
not earthed, connect the appliance to a separate earth in compliance with current regulations,
consulting a qualified electrician.
The manufacturer declines all responsibility if the above safety precautions are not observed.

5/ USE

First use
Before using the appliance for the first time, wash the interior and all internal accessories with
lukewarm water and some neutral soap so as to remove the typical smell of a brand new
product, then dry thoroughly.
Important!
• Do not use detergents or abrasive powders, as these will damage the finish.
• After transport, unpacking and installation, let the appliance rest at least 2 hours in vertical
position before connecting to the power supply.
• Let the appliance run for at least 2 hours before inserting fresh or frozen foods.
Temperature Setting
1.Key
A: Set key(Temperature setting button of refrigerator compartment)
2.Display screen
LED setting 1: 6°C
LED setting 2: 4°C
LED setting 3: 3°C
LED setting 4: 2°C
3.Display
Once initially powered on,the display screen is on full display for 3s,and then the refrigerator
runs according to setting 2 (4°C).in case of a failure,the corresponding LED blinks.in case of no
failures,it shows the actual temperature setting of refrigerator.
Ambient temperature
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
11
EN