Problem Solving - Miele Electro Premium SEB 236 Mode D'emploi

en
Adjusting the height (dia. 04)
The Electrobrush has five settings for
adjusting the distance between the
Electrobrush and the floor. The display
shows the setting selected.
Setting 1 - closest to the floor
Setting 5 - furthest away from the floor
 Press the foot switch repeatedly until
the required setting is reached.
Switching on and off (dia. 05)
 Press the connection socket release
button to release the Electrobrush. It
will now switch on.
The Electrobrush will switch itself off if
you bring the connection socket back
up to its upright position during vacu-
uming.
On/off switch on the handle
The electro-suction tubes (SES) have an
on/off switch on the handle which can
be used to switch the Electrobrush on
and off independently.
This switch enables you to switch the
Electrobrush off when you need to, for
instance when moving from carpeted
flooring onto a valuable rug.
Disconnecting the Electrobrush
(dia. 06)
 Press the release button and pull the
suction tube out of the Electrobrush
connection socket.
Multi-function indicator light.
The indicator light on the Electrobrush
lights up yellow to let you know that the
Electrobrush is switched on.
14

Problem solving

The multi-function indicator light is lit
up red.
The red light indicates a blockage in the
roller, for example due to a large item
being vacuumed up.
 Disconnect the vacuum cleaner from
the electrical supply immediately.
Switch off at the wall socket and un-
plug it.
 Remove the blockage.
 Press the indicator light.
This resets the blockage sensor.
 Reconnect the vacuum cleaner to the
mains supply and switch it back on.
The Electrobrush has switched itself
off automatically - the indicator light
continues to glow yellow.
The overheating protection mechanism
has been activated due to overheating
or a blockage.
 Disconnect the vacuum cleaner from
the electrical supply immediately.
Switch off at the wall socket and un-
plug it.
 Check the vacuum cleaner for any
blockages and check all the filters in
the vacuum cleaner.
The Electrobrush has to cool down. To
speed this up:
 Reconnect the vacuum cleaner to the
mains supply and switch it back on
together with the Electrobrush.
 Raise the connection socket to the
upright position.