Table des Matières
Publicité
SIGNODE BXT2-19
1
2
+
Fig. 17
AUTO
➟
=
MAN.
SOFT
flashing / intermitente /
Fig. 18
1
Fig. 19
24
3
=
2
1
AUTO
clignote
For Parts & Service 1-877-862-6699
6
SPECIAL FUNCTIONS
6.1 SWITCH TOUCH-PAD LOCK ON AND OFF
The touch-pad lock can be activated to prevent acciden-
tal changes to the settings.
– Press and hold the "Function" button (17/1) and press
the tension button (17/2) at the same time. The audible
signal sounds and the keypad is blocked. If any key is
pressed, the digital display will show „L" (Lock) (17/3).
– The keypad block is released in the same way as it is
activated.
6.2 SLEEP MODE
In order to avoid unnecessary battery consumption, the
tool changes after approx. 5 min. to sleep mode, if no
key is pressed.
– The digital display and the LED indicator are switched
off.
Sleep mode is switched off by touching any operating
panel element.
flashing / intermitente /
clignote
6.3 TOOL RESET
The tool reset may be used only if the rocker lever is
blocked:
Never attempt to lift the rocker lever by force.
– Change to mode of operation „Fully-Auto strapping"
(refer to Chapter 5.8).
– Press and hold welding button (18/1) and press
tension button (18/2). Tool reset starts (approx.
0.5 sec. welding).
If this procedure does not succeed, the blockage must
be cleared manually as follows:
– Insert the 3 mm Allen key supplied (19/1) through the
drilled hole and fit it into the cylinder screw (Pos.164/
page 34).
– Turn it counter-clockwise through ten full
rotations. This will require a little force.
– Lift the rocker lever and the welding mechanism must
swing upwards.
If the tool reset could not successfully carried out,
please contact the Service Centre!
07.15
Publicité
Table des Matières
Dépannage
