JVC GZ-MG555U Manuel D'utilisation page 48

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Changing the Menu Settings (Continued)
2 GAIN
You can set the ISO setting to
increase the sensitivity in dark
conditions.
{
CONTINUOUS SHOOTING
Records still images continuously
while the SNAPSHOT button is
pressed.
3 REC MEDIA FOR IMAGE
Enables you to set the recording
medium for still images.
g
BRIGHT
Enables you to set the brightness
of the LCD monitor.
^
DROP DETECTION
Prevents damage to the
HDD by turning off the power
automatically when the camera
detects that it has been dropped.
]
REMOTE
Turns reception of the operation
signal from the remote control
on/off.
[
DEMO MODE
Introduces special features of the
camera at the following cases.
When the menu screen is
closed.
When there is no operation
for about 3 minutes during
recording mode.
\
OPERATION SOUND
Enables you to set the operation
sound or turn the operation
sound on/off.
48
Menus
Settings: [ ] = Factory-preset
[AUTO] / 50 / 100 / 200 / 400
[OFF] : Disables the function.
ON : Activates the function.
BRACKETING : Activates the bracket shooting function.
In addition to an image with the exposure set by
the camera, two other images are recorded with
exposure values shifted to the + 0.3 EV and
EV sides. You can select the image that has a
suitable exposure after shooting.
NOTES
The interval between recording still images is approx. 1.0
seconds.
Continuous shooting may not work well depending on the
recording medium.
The continuous shooting speed will drop if this function is
used repeatedly.
[HDD] / SD
Adjust the brightness of the display moving the set lever
to £ / ¤, then press down.
OFF : Disables the function.
[ON] : Activates the function.
To turn the unit on when the drop detection worked, set
the power/mode switch to OFF, and to ON again.
CAUTION
Setting this function to off increases the chances of
damaging the built-in hard disk if the camera is accidentally
dropped.
OFF : The camera does not receive the signal from the
remote control.
[ON] : Enables operation with the remote control.
OFF : Disables the function.
[ON] : Activates the function.
NOTES
The demonstration only works when the DC cord is
connected, not with the battery.
If an SD card is in the camera, demonstration will not take
place even if this mode is set to [ON].
OFF : Turns off the operation sound.
[MELODY] : The melody sounds when any operation is
performed.
0.3

Publicité

Table des Matières
loading

Table des Matières