Epson WorkForce WF-M1560 Guide Rapide page 25

5. Before you open the new cartridge package, shake it gently four or five times. Then
remove it from the package.
Caution: Do not touch the green chip or the small window on the ink cartridge.
This can damage the cartridge.
6. Remove the yellow tape from the side of the ink cartridge.
Caution: Do not remove any other labels or seals, or ink will leak.
7. Insert the new ink cartridge into the holder and push it down until it clicks into place.
8. Lower the scanner unit.
9. Press to begin charging the ink. This takes about 2 minutes. When you see a
OK
completion message on the LCD screen, ink charging is finished.
Caution: Never turn off the product while ink is charging or you'll waste ink. If you see
an ink replacement message on the LCD screen, press
down securely. Then press
you cannot reinstall and use the cartridge.
Note: If you replaced the cartridge while copying a document, cancel printing and make
sure your original is still placed correctly on the document table. Then copy your original
again.
again. If you remove a low or expended ink cartridge,
OK
and press the cartridge
OK
Replacing the Ink Cartridge
25