After Using The Cleaner - Nilfisk ADVANCE POSEIDON VL500 Séries Mode D'emploi

Masquer les pouces Voir aussi pour ADVANCE POSEIDON VL500 Séries:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3 Maintenance
3.1
Maintenance of the float
system
3.2
Maintenance

4 After using the cleaner

4.1
After use
4.2
Transport
4.3
Storage
4.4
Warranty
4.5
Recycling the cleaner
10
Remove the electrical plug from the socket before performing main-
tenance. Always empty and clean the container and the float system
after picking-up liquids. Release the front latch by pulling it outwards
so that the motor top is released. Open up motor top from container.
Then loosen the float basket by turning the basket to the left. Remove
the complete float system from motor top. A filter is located in front of
the motor inlet. Check this motor filter. Replace with new filter if filter
is clogged. Wipe the float valve and float basket with a damp cloth be-
fore the motor top is reinstalled to the container. Then reinstall the float
valve to the float basket. Make sure that the sealed surface of the float
valve is installed upwards in direction towards the motor top. To mount
the float basket - fit the arrow at the basket to the arrow. Then secure
the float basket by turning it to the right.
Remove the plug from the socket before performing maintenance.
Before using the machine make sure that the frequency and voltage
shown on the rating plate correspond with the mains voltage.
Specifications and details are subject to change without prior notice.
The accessories shown in the pictures may vary from model to model.
Always keep the cleaner in a dry place. The cleaner is designed for
continuous heavy work. Depending on the number of running hours –
the dust filters should be renewed. Keep the container clean with a dry
cloth, and a small amount of spray polish.
For details of after sales service contact your dealer.
Remove the plug from the socket when machine is not in use. Wind up
the cord starting from the machine. The power cord can be wound up
around the handle/hooks located on the motor top or at the container.
Some variants have special storage places for accessories.
Before transporting the dirt tank, close all the locks.
Eventually take off the motor top/container from the trolley
(VL500 55/75).
Do not tilt the cleaner if there is liquid in the dirt tank.
Do not use a crane hook to lift the cleaner.
Store the appliance in a dry place, protected from frost.
Our general conditions of business are applicable with regard to the
guarantee.
Unauthorised modifications to the appliance, the use of incorrect
brushes in addition to using the appliance in a way other than for the
intended purpose exempt the manufacturer from any liability for the
resulting damage.
Make the old cleaner unusable.
1. Unplug the cleaner.
2. Cut the power cord.
3. Do not discard of electrical appliances with household waste.
As specified in European Directive 2002/96/EC on old electrical
and electronic appliances, used electrical goods must be collected
separately and recycled ecologically.
Original instruction

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Vl500-35Vl500-55Vl500-75

Table des Matières