Makita LXJP02 Manuel D'instruction page 6

1
5
4
012499
1
2
3
10mm
10mm
4
012500
The angle of the fence can be adjusted between 0° and
90° (positive stops at 0°, 45° and 90°). To adjust the
angle, loosen the lock lever and tilt the fence until the
pointer points to the desired graduation on the angle
scale. Then tighten the lock lever to secure the fence.
When the fence is set at 90°, both the distance from the
center of the blade thickness to the fence and the
distance from the center of the blade thickness to the
bottom of the blade cover are 10 mm (0.4").
Set plate
2
5: 3
4mm
4
10mm
10mm
6
6mm
012258
1
012501
Use the set plate as shown in the figures when cutting
slots in thin workpieces.
1. Fence
2. Angle scale
3. Lock lever
4. Tighten
5. Loosen
3
2
1. Lock lever
2. Pointer
3. Angle scale
4. Center of blade
thickness
5. Blade cover
5
1. Lock lever
1
2. Pointer
3. Angle scale
4. Set plate
5. Thickness of set
plate
6. Center of blade
thickness
7
7. Blade cover
1. Set plate
Switch action
1
012512
CAUTION:
Before installing the battery cartridge into the tool,
•
always check to see that the slide switch actuates
properly and returns to the "OFF" position when the
rear of the slide switch is depressed.
Switch can be locked in "ON" position for ease of
•
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, slide the slide switch toward the "I (ON)"
position. For continuous operation, press the front of the
slide switch to lock it.
To stop the tool, press the rear of the slide switch, then
slide it toward the "O (OFF)" position.
Indication lamp with multi function
012513
Indication lamps are located in two positions.
When the battery cartridge is inserted on the tool with the
slide switch positioned in the "O (OFF)" position, the
indication lamp flickers quickly for approximately one
second. If it does not flicker so, the battery cartridge or
indication lamp has broken.
− Overload protection
− When the tool is overloaded, the indication
lamp lights up. When the load on the tool is
reduced, the lamp goes out.
− If the tool continues to be overloaded and the
indication lamp continues to light up for
approximately two seconds, the tool stops.
This prevents the motor and its related parts
from being damaged.
− In this case, to start the tool again, move the
slide switch to the "O (OFF)" position once
and then to the "I (ON)" position.
6
1. Slide switch
1. Indication lamp
1