Operation; Before Charging Batteries; Connecting The Battery - AEG LK 1204 Mode D'emploi

24

OPERAtIOn

Before charging batteries

▪
If the battery must be removed from the vehicle before charging, always discon-
nect the earthed connector from the battery first. Also ensure all other loads in
the vehicle are off.
▪
Ensure adequate ventilation to allow any toxic vapours or gasses to disperse.
▪
Ensure the battery poles are clean. If the battery has a removable vent cap, fill
each battery cell with distilled water to the manufacturer recommended level. Do
not overfill the cells.
▪
If the battery does not have caps, refer to the manufacturer instructions on char-
ging and the charging speed.

Connecting the battery

Risk of electrical shock!
Always verify the charging device is disconnected from the 230 V Ac
outlet when connecting to a battery.
▪
Always ensure the area around the battery is well ventilated during the charging
process.
1. connect the positive charging clamp (red) to the positive battery terminal
(marked P or +).
2. connect the negative charging clamp (black) to the body of the vehicle, or in
exceptions to the negative battery terminal (marked n or -).
3. Verify both terminal clamps make good contact with the respective terminals.
4. Plug the power plug into a suitable Ac mains outlet.