Functions; Operation; Before Use; Connecting The Device - AEG WM 6 Mode D'emploi

Functions

The charger is equipped with a microprocessor
(MCU - Micro Computer Unit) and features fully
automatic diagnostic, charging, and maintenance
functions. If the wrong battery voltage is set or the
battery is defective, it will not charge and the "Error"
LED (7) will light up (also see "troubleshooting").
the "trickle charge" function allows the charger
to be permanently connected. A full charge will be
maintained.

OPERAtIOn

Before use

Warning!
Before using this device be sure to read the ope-
rating manual for the battery and the vehicle and
understand all safety notices.
•
Use safety goggles and acid-proof safety gloves.
•
Ensure adequate ventilation.
•
Ensure the battery poles are clean. If the battery
has removable vent caps, fill each battery cell with
distilled water to the level recommended by the
battery manufacturer. Do not overfill the cells.
•
If the battery must be removed from the vehicle
before charging, always disconnect the earthed
connector from the battery first. Also ensure all
other loads in the vehicle are off.
•
If the battery does not have caps, refer to the
manufacturer instructions on charging and the
charging speed.

Connecting the device

6 V 2 A
12 V 2 A
12 V 10 A
Mode
10 A
1. Connect the red (+) terminal connection cable
2. Connect the black (-) terminal connection cable
Note:
The black (-) clamp can also be connected to the
vehicle chassis (Please refer to the auto maker's in-
structions!). Be sure both clamps have good contact
and are securely seated.
Risk of fire and electric shock! If possible, connect
the charger to the 230 V power socket without
extension cable. In exceptions, use the shortest
possible undamaged and unrolled 230 V extension
cable.
3. Plug the charger plug into a 230V power socke.
the display shows the current battery voltage.
10 seconds after starting, the „Charge" LED (8)
will light up and the charging voltage will be at the
preset lowest charging rate.
If the battery is connected incorrectly, the "Error"
LED (7) will light up. In this case, unplug the charger
and check the battery and the correct connection
(also see "troubleshooting").
4. Verify the device's preset charging voltage
5. You may repeatedly press the MODE button (10)

Start charging

If the charging device is correctly connected it will
automatically start charging.
the "Charge" LED (8) will light up.
V
A
%
V/A/%
the charging process is fully automatic.
When the battery is fully charged, the "Full" LED (9)
will light up and the "Charge" LED (8) goes out.
Note:
Once the battery is fully charged, the charger will
switch to trickle charge to maintain the charging
status and protect the battery from overcharging.
with clamp (6) to the positive battery terminal.
with clamp (5) to the negative battery terminal.
Warning!
(6 V or 12 V) corresponds with the connected
battery. If the charging voltage is too high, the
connected battery may be damaged/destroyed.
during charging to select the charging voltage,
charge in %, and the charging current (see „Char-
ging current").
English 19