Technical Specifications - LAVAZZA Jolie Mode D'emploi

Problem encountered
Machine does not turn on.
Power light is off after
having pressed the Switch-on/
supply button.
The machine requires a lot of
time to heat up.
The machine is very noisy.
The loading lever doesn't reach
the brewing position.
Red flashing light .
Pilot light ON with white
light and blinking fast.
The coffee flows out too fast and no
creamy froth forms on the surface.
Coffee not supplied and steam
coming out of the capsule
compartment.
No coffee flows out or it just
drips out slowly.
• Nominal Voltage - Power Rating - Power Supply:
See label on the appliance
• Measurements: Height
214 mm
• Weight: approx. 2.5 kg
• Water tank: 0,6 L - Removable type
TROUBLESHOOTING
Possible causes
» Machine is not connected to
the power source.
» The machine has limescale
build-up.
» No water in the tank.
» Spent capsule drawer filled.
» Capsule fitted incorrectly.
» Machine error.
» Machine broken.
» Spent capsule drawer filled.
» Capsule already used.
» The loading lever was not set
to the brewing position.
» Dispensing spout is clogged.

TECHNICAL SPECIFICATIONS

Width Depth
124 mm 330 mm
Solution
» Connected the machine to the power source.
» Contact customer service.
» Descale the machine.
» Top up the tank with fresh drinking water.
» Empty the spent capsule drawer.
» Repeat the sequence, lever in the off position, lever
in the brewing position; if this is not enough, operate
manually to remove the capsule from the duct with
the machine disconnected from power mains.
» Disconnect and reconnect the power plug.
» Contact customer service.
» Empty the spent capsule drawer and press the
power-on/coffee supply button to reset the coffee
machine.
» Bring the lever back to rest position and load a new
capsule.
» Set the loading lever to the brewing position.
» Clean the coffee dispensing spout
(see MAINTENANCE AND CLEANING).
• Housing materials: Thermoplastic
• Cable Length: 0,8 m
• Thermo fuses
• Instantaneous aluminum boiler with temperature
probe
25
E N