Carbon Brushes; Ordering Replacement Parts; Disposal And Recycling - EINHELL RG-CH 18 Li Mode D'emploi

Anleitung_RG_CH_18_Li_SPK7:_
GB
brush.

7.2 Carbon brushes

In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
7.3 Maintenance
The cutters should be cleaned and lubricated at
regular intervals in order to ensure best
performance at all times. Remove deposits with a
brush and apply a thin film of oil (Figure 11).
There are no parts inside the equipment which
require additional maintenance.
The hedge trimmer with the cutter guard and
cuttings collector fitted can be hung on a nail,
screw or the like for storage using the hole in the
impact guard (Fig. 12).

7.4 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
9. Faults
The device does not operate:
Check whether the rechargeable battery is charged
and whether the battery charger works. If the device
still does not work even with a voltage supply, please
send it to our customer services department at the
address indicated.
12
30.03.2009 13:45 Uhr Seite 12