Connecting and disconnecting the gas bottle
Parts and tools needed
excluded
The tube shall be readily visible across its entire length f
inspection after installation.
DANGER! IGNITION OF ESCAPING GAS
Possible consequences:
Safety measures:
Operational Elements:
lever/
9 o,clock setting or rotate clockwise to the end:
Cylinder valve
12 o,clock setting or rotate anti-clockwise to the end:
than
LIGHTING INSTRUCTIONS:
1. READ OPERATING INSTRUCTIONS BEFORE LIGHTING.
2. OPEN LID.
3. ENSURE KNOBS ARE IN "●" POSITION.
4. CONNECT REGULATOR WITH CYLINDER,THEN TURN ON.
5. PUSH AND TURN CONTROL KNOB TO " "POSITION, KEEP PRESSING
THE CONTROL KNOB DOWN AND PUSH THE IGNITER BUTTON BY
ANOTHER HAND UNTIL THE BURNER IS LIT. AFTER IGNITION, KEEP THE
or
CONTROL KNOB PRESSED DOWN FOR APPROX. 20 SECONDS. THEN
RELEASE THE CONTROL KNOB.
6. ADJUST THE FLAME BETWEEN 1/4 TO 1/2 AREAS.
! WARNING
OUTDOOR USE ONLY. IF IGNITION DOSE NOT OCCUR WITHIN
5 SECONDS, TURN CONTROL KNOB(S) TO "●". WAIT 5 MINUTES
TO ALLOW GAS TO DISSIPATE AND REPEAT LIGHTING PROCEDURE.
ACCESSIBLE PARTS MAY BE VERY HOT, KEEP YOUNG CHILDREN AWAY.
DISCONNECT REGULATOR FROM CYLINDER WHEN THIS APPLIANCE
NOT USE IN A LONG TIME.
WARNING:
LID MUST BE OPEN WHEN BURNER IS ON OR HOT.
MAXIMUM WEIGHT ON SIDE SHELF: 6.8 KG / 15 LB
Function
rotate to the end
cylinder
Note
1-A
G5
9
G1
G2
12
G3
G4
1/4 position
1/4 to 1/2.
1-B
G1
G2
9
G4
1008
G2
G4
setting or anti-clockwise
opened
G2
G4