Connection Of The Devices; Operation; Cleaning And Maintenance - EuroLite 51928720 Mode D'emploi

Connection of the devices

P3 = 2-pin power supply lead socket
Ω
P4 = 120 . termination plug (end piece)
Attention: A booster must be installed after every 15 LED Panels 60 x 60cm, or 30 LED Panels 60 x 30cm
for signal enforcement.

OPERATION

Connect the fixtures to the mains with the power-plug. After every 45 LED panels, the fixtures must have a
renewed connection with the power mains.
Panels can now be controlled via the EUROLITE C-1 DMX Controller.

CLEANING AND MAINTENANCE

DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers. Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by authorized dealers only
in order to avoid hazards.
14/27 51928720_V_1_0.DOC