Components And Accessories; User Instructions; Starting The Machine; Making Espresso (Brt-Brtn-Brte) - La Pavoni BARETTO Mode D'emploi

English
10 – COMPONENTS AND ACCESSORIES
SERIE SERIE BRT - BRTP - BRTE
1. Cold water tank
2. Cupwarmer
3. Gauge
4. Steam/hot water knob
5. Coffee group
6. Steam/hot water supply nozzle
7. Removable cup grid
8. Pressurized filter holder
9. Pods filter (BRTP-BRTPN)
9. Single cup filter/pods filter (BRT-BRTE-BRTN)
10. One-cup and two-cup filters (BRTP - BRTPN)
10. Two-cup filters (BRT-BRTE-BRTN)
11. Filter holder standard BRT-BRTE-BRTN
ACCESSORIES BRT-BRTE-BRTN
Pods filter (9)
1 cup and 2 cups filters (10)
Insert for coffee capsules (17)
Coffee measure (19)
Pressurized filter holder (8)
User's Manual (18)
ACCESSORIES BRTP-BRTPN
Single cup filter/pods filter (9)
2 cups filter (10)
Coffee tamper (12)
Coffee measure (19)
Pressurized filter holder (11)
User's Manual (18)
SERIE BRTN - BRTPN
12. Coffee tamper
13. On/off lever
13a. Lamp: machine on
14. Coffee/hot water lever
14a. Warning light: coffee / hot water lever
15. Steam switch
15a. Warning light: steam switch / machine ready
16. Cappuccino Automatic (BRT-BRTE-BRTP)
17. Insert for coffee capsules
18. User's Manual
19. Coffee measure
20. "Fascino" Filter holder (Optional)
26
11 – USER INSTRUCTIONS
11.1 – STARTING THE MACHINE
a) Fill the tank (1) with cold water.
b) Switch the machine on by pushing the on/off lever (13) on the position "I". The lamp (13.a) comes on to
confirm the power supply.
c) Insert the filter holder in the coffee group.
d) Open the steam/hot water knob (4).
4
Place the water/coffee water lever (14) and the steam lever (15) on the position "I"
Should water comes out of the turbo steam supply nozzle (6), push the hot water/coffee lever (14) and the steam
lever (15) on the position "0" and close the knob (4).
1
e) Please, check the tank water (1) level so to prevent from repeating these operations and from empting water
circuit. In case it happens, repeat all the above mentioned operations by all means..
f) After doing these operations, wait that the machine builds up the operating temperature to make coffee, lamp
6
(15a) on.
11.2 – MAKING ESPRESSO (BRT-BRTN-BRTE)
Make sure to follow the instructions as per 11.1 "starting of the machine".
To make a good cup of espresso you need good quality coffee, properly roasted and ground.
The pump espresso coffee machine requires finely ground coffee. If the coffee is too coarsely ground the coffee
will be light and without the froth that marks a good cup of espresso. If the coffee is ground too finely the espresso
will be dark and strong and have little froth.
We recommend grinding the coffee beans with a traditional grinder (not a grinder that uses a blade) immediately
before you make the coffee since the coffee quickly loses its aroma after it is ground.
A prewarmed cup helps keep the espresso at the right temperature. We recommend placing the cups on the
cupwarmer (2) before use.
a) Make sure there is enough water in the tank (10).
b) Depending on the number of cups of coffee you wish to make, place the one-cup filter (9) or the two-cup filter
(10) into the filter-holder (11) and insert the filterholder into the coffee group (5) with a left-to-right turning motion
until it locks in order to preheat it.
c) Turn on the ON/OFF switch (lever switch/switch) (13). The ON light (13a) will come on to show that the
machine is operating.
One cup filter is suitable for pods use. The pod must be put into the filter taking care that the
filter paper doesn't extend beyond the edge of the filter holder.
d) Wait the machine reaches the temperature in order to supply a coffee, lamp (15a) on . .
e) Remove the filter-holder (11), fill the filter with one or two measures of ground coffee (one measure per cup)
(Photo 4), level and press the coffee firmly but not excessively with the coffee press (12).
f) Clean any remaining coffee from the edge of the filter with your hand and insert the filter-holder (11) into the
coffee group (5), turning it to the right to lock it.
g) Place one or two prewarmed cups on the cup rest grid (7) under the filterholder.
h) Turn on the coffee/hot water switch (14). Espresso coffee will begin to flow out of the spout of the filter-holder
27
English