Technical Specifications - afx light MINI-BEAMWASH Manuel D'utilisation

The following points have to be considered during the inspection:
All screws for installing the devices or parts of the device have to be tightly connected and must not be corroded.
There must not be any deformations on the housing, glass pane, fixations and installation spots.
The electric power supply cables must not show any damage, material fatigue or sediments. Further instructions
depending on the installation spot and usage have to be adhered to by a skilled installer and any safety problems
have to be removed.
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol or solvents.
CAUTION: Disconnect from mains before starting maintenance operation!
Cleaning and Using Frequency of Product
Please make sure that the light is power off before dismantling or maintaining, it's very important to keep the light
clean. Frequent cleaning will ensure maximum brightness output, but also prolong the life time. It's suggested to use
the high quality, professional glass detergent and soft cloth to clean the light. It's not allowed to use alcohol or
chemical solvent. The inner part of the light should be cleaned by vacuum cleaner at least once a year.
When the light doesn't work, please check if the fuse is burnt out or not. If it is, the same fuse should be replaced,
find out the faulty and restart the light. But please note the repair must be handled by professional.

TECHNICAL SPECIFICATIONS

Channels: .......................................................................................... 10/18 DMX Channels
Control mode: .................................................. Sound activated, Auto, Master/ Slave, DMX
Wash face LED power: ............................................... 4 x 10W RGBW LEDs (4 in 1 ) LEDs
Wash angle: ..................................................................................................................... 25°
Beam face LED power: .......................................... 12W RGBW LEDs (4 in 1 ) CREE LEDs
Beam angle: ....................................................................................................................... 3°
Working environment: .......................................................................... indoor, 20°C – 40°C
Voltage: .................................................................................................. AC 100-240V ±10%
Frequency: ............................................................................................................... 50-60Hz
Power: ............................................................................................................................ 70W
Dimensions: .............................................................................................. 325X250X270mm
N.W .............................................................................................................................. 2.5Kg
Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your
local authorities or your dealer about the way to proceed.
© Copyright LOTRONIC 2015 MINI-BEAMWASH Page 10