Product Description; Safety Information - Weka 209.2520.00.12 Notice De Montage, D'utilisation Et D'entretien

Assembly conditions for a weka assembly team
If you wish for help assembling your cabin and choose to employ a weka assembly team, weka Holzbau
GmbH will carry out the following services for you:
Assembly means putting together (installation) of the individual parts supplied.
It does not include treating them with a wood protection agent, the delivery and assembly of accessories and
accessory parts.
Electrical connections are not included in the assembly service.
The items to be assembled must be located at the installation site/location/base area.
Transport of the article or the individual parts over a distance greater than 10-15m or to another level is not
included in the assembly price quoted.
The substrate must be stable, horizontal and level.
In the event of doubt, reference should be made to DIN 18202 'Level tolerances in building construction',
tab. 3, row 3, with a maximum height difference at the furthest points of approx. 10 to 11 mm.
All preparatory work must have been carried out in accordance with the technical regulations before
assembly begins.
The substrates/floors/foundations constructed or selected by you must be suitable for the assembly.

Product description

General functions and area of application
The cabins are intended exclusively for the storage of garden equipment etc. or as a place to relax for a
short while and enjoy your garden.
You are not permitted to use the cabin as a residence or heated accommodation.

Safety information

Selection of the substrate
The ground under the cabin should be level, horizontal and built up. If your cabin is located near slopes and
basements, you should consult a local builder. Otherwise, there may be a risk of collapse.
Built-up ground must be compressed to ensure that the cabin does not sink, otherwise damage may occur.
Any turf must also be removed.
Space requirements
The space required depends on the size of your cabin.
The cabin must always be accessible from the outside on all sides to allow for inspection, ventilation and
protection against weathering.
The space required should be approximately 1.0 – 1.5 m larger than your cabin on all sides.
Safety information and warnings
In order to prevent accidents, we recommend that children be kept out of the direct vicinity during assembly.
During assembly, children under the age of 14 should be kept at least 3 m from the assembly site.
The current occupational safety and accident prevention regulations are to be observed.
Information can be obtained from a builder.
The roof is only to be accessed on load-distributing boards.
When you are working on a roof, avoid the risk of falling by complying with the current accident prevention
regulations (e.g. scaffolding requirements, safety rails).
Agree the required measures and operating conditions with a local builder or competent work safety
authority.
Always work with helpers!
When unpacking the loose wooden parts and when assembling the cabin, we recommend that you wear
safety boots and work gloves. When using a drill or saw, you should also wear protective goggles.
The roof is to be cleared of high snow loads (in excess of 0.75 kN/m² or approx. 30 cm in height).
 Copyright weka-Holzbau GmbH, Neubrandenburg
7
Techn. Änderungen vorbehalten!