Pre-Installation Check - Swann SWIFI-FLOCAM2 Guide De Démarrage Rapide

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

PRE-INSTALLATION CHECK

WI-FI COVERAGE AVAILABILITY
Before you begin the installation of the product, it is important that you confirm the availability of
Wi-Fi as well as the signal level at the desired installation location.
Note that Wi-Fi quality can vary significantly at different locations around the home due to
environmental factors such as home construction type and wireless interference from other
electronic devices.
TO CHECK WI-FI COVERAGE
1
Connect your phone to the 2.4GHz Wi-Fi network band of your internet/broadband router.
Note: The Swann Floodlight Security Camera will only connect to a 2.4GHz network.
2
Place your phone where you are planning to install the floodlight unit. If you have Wi-Fi connection
on your phone, the camera will also likely be able to obtain Wi-Fi connection. Check the Wi-Fi icon
on your phone. We recommend a minimum of 1 bar showing on your phone's Wi-Fi icon as shown
below. Further testing should be performed if the Wi-Fi signal strength is only 1 bar.
X
0
1
No connection
Poor
!
2
3
Fair
Good
Number of bars indicate
4
Wi-Fi signal strength
Excellent
EN
3

Publicité

Table des Matières
loading

Table des Matières