BoomToneDJ SIX EYES RGB Mode D'emploi page 17

Channel DMX Value
CH1
CH2
CH3
CH4
CH5
CH6
CH7
CH8
1. If you are using a controller with 5 pins DMX output, you need to use a 5 to 3 pin
adapter-cable.
2. At last unit, the DMX cable has to be terminated with a terminator. Solder a 120 ohm
1/4W resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug
it in the DMX-output of the last unit.
3. Connect the unit together in a 'daisy chain' by XLR plug from the output of the unit
to the input of the next unit. The cable can not be branched or split to a 'Y' cable.
DMX512 is a very high-speed signal. Inadequate or damaged cables, solder joints or
corroded connectors can easily distort the signal and shut the system down.
4. Each lighting unit needs to have an address set to receive the data sent by the
controller. The address number is between 0-511 (usually 0 & 1 are equal to 1).
Description
0-255
Dimmer
0-255 Red color
0-255
Green color
0-255
Blue color
0-255
Strob
0-255 Motor position
Rotation
0-127
128-255 Rotation reversed
0-255 Colors Combinations
16